Solid wood countertops are all-natural products made from wood from trees around 120 years old. Wood is a living product and the more dampness receives, the a lot more the timber countertop will certainly increase. The wood we utilized in strong wood worktops has been formerly kiln dried out to a moisture level of 6%, as well as it is consequently essential that the worktop is not subjected to a frequently high level of humidity. Usually the moisture degree in cooking areas is approximately 50-70%.
The solid wood top need to be affixed to the closet box using only wood screws and washers. It is not suggested in any way to adhesive the top on the cupboard box; the leading as well as package broaden and also get at various prices, consequently splits could at some point show up, most likely on the closets' surface area.
The appropriate method of setting up a solid wood top is using steel fixings along the cabinet box (see our website).
The steel correctings need to be consistently distributed throughout the length of the top, spaced at a 1' - 1.5' range from each various other. Across the width, the top is generally dealt with to each steel support with 3 screws, one between, one toward the leading edge and also one towards the rear side. The assistances should be perfectly leveled; or else tensions can develop in the timber, resulting in warping, cupping, or splits.
We suggest pre-drilling the screw holes right into the wood kitchen counter, to avoid cracks and also splits. For the same factor, it is a good suggestion not to over tighten the screws. The ending up will live edge dining table significantly diminish the degree of such movements, however will not remove them altogether. Because of the panel's laminated framework, the lengthwise motions are insignificant, so the installer must pay attention to the motions taking place across the panel's size. In order to prevent the advancement of internal tensions, the holes in the steel repairings must be lengthened in the instructions of the movements (see our web page ).
When revealed to normal humidity degrees - i.e. 50-60% - the worktop's size will certainly expand by 1/12"-1/ 24", however when revealed to a degree of 80-90%, this measurement may broaden by approximately 1/2" or perhaps much more for some types. Consequently, when the back side of the counter top is installed against a wall, the wall may limit the top's all-natural activities, leading to undesired tensions in the wood. To avoid this, you can allow a 1/4"-1/ 2" joint between the wall as well as the counter top edge as well as caulk it with a thin quote of acid-free silicone.
Furthermore, you can securely take care of the back edge to the metal supports underneath and thus, allow the natural activities to take place at the expenditure of the contrary edge.
In this situation, the holes in the metal fixings corresponding to the back side will certainly be no larger than the screws diameter, while the openings representing the middle section and the leading edge will certainly be lengthened.
For extra information concerning the installation of timber counter tops, bar tops as well as kitchen islands, please see our websites.